Knife Pliers
Knife Pliers
 |
 Gerber Knives New Diesel Mossy Oak Knife Tool G41380  US $68.88
|
 WINCHESTER MULTI TOOL KNIFE AND CASE - PLIERS ECT L@@K US $35.00
|
 NEW BUCK KNIVES 732BLS BLUE X-TRACT TOOL LOCK KNIFE US $33.99
|
 Large Victorinox Handyman Swiss Army Knife US $6.26
|
 Multi Purpose Tool Leatherman Style Pliers, Knife, Can Opener, Screw Driver, Etc US $1.75
|
 Victorinox Tinker Deluxe Swiss Army Knife US $11.50
|
 Victorinox Mechanic Swiss Army Knife US $6.99
|
 Husky 25th Anniversary Limited Edition Knife Multi Tool US $6.95
|
 Gerber Knives Bear Grylls Compact Multi Tool New 0750 US $8.00
|
 Gerber Method Spring Action Needlenose Multi-Plier Tool US $22.00
|
 Victorinox Swiss Army SwissChamp Forest Green US $62.00
|
We have had a couple of requests for information about installing carpet on your boat. First let me give the advice that installation of marine carpet should be installed by a professional installer. Also, this guide is for glue down boat carpet only; snap in carpet mats can only be done by a professional with the proper tools. Now that we have that out of the way... Here is a list of tools needed.
carpet knife
Needle nose pliers
marine glue
1/16 trowel
tape measure
marker
scraper
shop vac
scissors
Start in a corner by grabbing the carpet with the pliers. Gently pull back slowly, as to not tear through the carpet. Once the old carpeting is completely pulled out; set it aside for later. Use the scraper to remove the remaining dry carpet glue from your boat. If it isn't working, try using a piece of sandpaper. But don't overboard and ruin the bottom of your boat.
Now grab your new carpet and roll it out. If it is stiff and curling, leave it in the sun for a little bit to soften up. Now flip the carpet over so the backing is upright. Place your old carpet overtop of it with the backing facing up as well. Use the marker and trace out the old carpet on top of the new carpet. Once that is done, use either a knife or scissors to cut your carpeting out. For those who do not have existing carpet, you will have to lay the carpet inside your boat and cut the carpet to your fitting. It is not difficult but can be time consuming.
Now set your new marine carpeting inside your boat. Adjust it to fit exactly as it should when it is glued down. Set down something heavy like a toolbox or a case of beer on one side of the boat. Now flip the other side over. Start spreading the glue onto the boat using the 1/16 trowel. Do not use to much glue or else the carpet will bubble feel much different under your foot. Once the entire side has been glued; gently set the carpet overtop. If you have the ability to rent or borrow a 100 pound roller; use it to go over the glued carpet. This will prevent air bubbles and ripples. Now repeat on the other side and your all done. Enjoy your new carpet.
Leatherman Skeletool CX Review - Knife, Pliers, Drivers